Trinity Alpha 70K TMA 7590, Product Description And Assembly Manual

Page: 13 / 48

www.energyabsorption.com Revision B December 2013
www.highwayguardrail.com 12 All rights in copyright reserved
Recommended Tools

Welding equipment (for 13 mm [1/2”] plate)

Cutting torch

Hammer

Drift pin or alignment pin

Tape measure

1/2" drive socket wrench

1/2" drive sockets (9/16”, 1-1/8”, 1-1/2”)

Open end wrenches (9/16”, 1-1/8”, 1-1/2”)

12” crescent wrench – 2

Carpenter’s 600 mm [24”] bubble level

Marking implement (pencil, soap stone)

Floor jack

Center punch

Torque wrench

Hydraulic fluid (Use Dexron
®
III fluid only)

Drill motor for 13/16” diameter drill

13/16” diameter bit and pilot drill for same

9/16” Allen wrench
Note:
The above list of tools is a general recommendation. Depending on specific site
conditions and the complexity of the assembly specified by the appropriate highway
authority, additional or fewer tools may be required. Decisions as to what tools are
needed to perform the job are entirely within the discretion of the specifying highway
authority and the authority’s selected contractor performing the assembly of the system
at the authority’s specified assembly site.