9
Panic is disabled by pressing any fob button (other than the Panic button) or unlocking the
entrance door via the keypad.
Replacing the 32-Bit CAN Keypad
For improved security/theft prevention, the keypads and e-
ASK
controllers are paired at the
factory to prevent swap-out violations. If the keypad is changed, the keypad will play a 2
second error beep. The Keypad will not lock/unlock or perform any other keypad functions.
Pairing procedure as follows for replacing a keypad in the field:
•
Plug the new keypad into the Prevost harness
•
Place an authorized fob inside the vehicle
•
Active the Start button described in the first paragraph of this manual
•
Once the fob is found, pairing occurs automatically
•
Access codes are stored in the keypad. If the keypad is replaced, new user access
codes must be entered. See “
Replacing the e-
ASK
Module
•
Plug the new e-
ASK
module into the Prevost harness
•
Run an unlock command from the keypad (4- digit access code + 1/2 button)
•
Fobs serial numbers are stored in the e-
ASK
module. If you replace the e-
ASK
module,
you must re-learn fobs. See “
Troubleshooting
e-
ASK
Module Status LED’s
These LED’S are on the e-
ASK
module’s circuit board. Light pipes in the case help the visibility
of the LED’s. The label on the e-
ASK
module provides basic descriptions, here is the full list of
available codes
.
Green
LED
Red LED
Software Mode
Software Mode / Current State
On
Off
Customer Mode
RUNNING power state
Fast blink Off
Customer Mode
INITIALIZE power state
Periodic
blink
Off
Customer Mode
PENDING SLEEP
Off
Off
Customer Mode
SLEEPING power state. Low-power sleep state.
Off
Slow blink for X
cycles then pause
Customer Mode
Run-time error detected, see table below
Fast blink Fast blink
Fob Learn Mode
Waiting for fob input to add fobs to the Authorized
Fobs List
Fault
Run-Time
Error Blinks
CAN Bus Communication Error
1
CAN Voltage Out of Range, High, Above 5V
2
LF Module Communication Error
5
