©1997-2015 TRIKDIS
15
www.trikdis.com
Controller GV15 Controller operation and configuration with “TrikdisConfig”
Administrator parameters
To form a list of administrators authorized for dial control or SMS sending to control both relays, go to the program
menu Administrator list, section Administrators. It should be also indicated in the section which relay will be
controlled by call and which events will be reported to the administrator by receiving SMS. For SMS message text
changing, see 6.7.1 Message text parameters.
The administrator may control the relays just with a call indicating the relay to be controlled, or by call using "DTMF"
tones. During "DTMF" tones dial control, after a call was made the command must be entered and preferred relay
for control must be selected. This function is enabled by marking the checkbox next to DTMF tones control. For
"DTMF" tones call commands, see 9.2 “By DTMF tone phone call“.
Administrator parameters
Name
Description
Administrator
name
Administrator name
Phone No.
Administrator phone number must be entered in international format using prefix "+".
Relay 1
Dial control of Relay 1 will be enabled when checked.
Relay 2
Dial control of Relay 2 will be enabled when checked.
IN1
SMS message sending after input IN1 actuation will be enabled when checked.
IN2
SMS message sending after input IN2 actuation will be enabled when checked.
OUT1
SMS message sending after Relay 1 actuation will be enabled when checked.
OUT2
SMS message sending after Relay 2 actuation will be enabled when checked.
Test
Periodic test report sending will be enabled when checked. For more details, see 6.8
“Periodical “.
ACK
Sending replies to SMS command requests will be enabled when checked.
Note. The controller will not operate and control by persons specified in User list will be disabled unless every
single administrator name (not exceeding 28 symbols) and phone number (not exceeding 16 digits) is properly
entered.
Administrator parameters
Note. "DTMF" tones dial control is not possible, if dial control mode All was selected.
