Product manual DALI MSensor 5DPI 14 | 06-2017 | 1.1 | en
Special DALI settings
c
34 / 48
7.2.5. Dimming (DALI "Up" or "Down" command)
Constant light control
This behaviour can be adjusted in the masterCONFIGURATOR configuration software:
Presence control
7.3. Implementation of DALI commands in other comfortDIM controllers
If the DALI MSensor is combined with other comfortDIM controllers in a DALI circuit, its behaviour can be influenced
by the above-mentioned DALI commands. The following matrix lists those commands that are output by a particular
device.
DALI command
or device type
Direct setpoint
invocation ("Direct
Arc Power x")
Switch on at
maximum value
("Recall Max")
Switch off
("OFF" or
"Direct Arc
Power 0")
Recall
scene
("Recall
Scene x")
Dimming
("Up" or
"Down")
DALI GC
DALI SC
I
NOTICE
Scene recalls are sent both to the DALI MSensor and to the ballasts of the luminaire group. This may result in
contradictory responses! To prevent this, proceed as follows:
_
In the ballast, select the "MASK" setting if one of the three "automatic", "off" or "MASK" settings has been
selected in the DALI MSensor.
_
If the MSensor is used in combination with an x/e-touchPANEL it is recommended to set the scenes with
the x/e-touchPANEL.
Luminaire group is dimmed, light control is temporarily deactivated or
_
Luminaire group is dimmed. The brightness value measured after dimming is accepted as the new temporary
brightness setpoint for constant light control. At the next switch-on, constant light control is reset to the
previously stored brightness setpoint.
_
In switched-off state:
the presence detector ignores the command and remains in the "off" state.
_
In switched-on state:
the presence detector remains in its respective state, the motion sensor profile continues.
_
Summary of Contents for luxCONTROL DaLI Msensor 5DPI 14
Page 5: ...luxCONTROL DALI MSensor 5DPI 14 Product Manual ...
Page 6: ...c 2 48 ...
