Revision: 0
FlexxPump1 B
User Manual
40
EN-
6.3.10 FIL-Menu
The FIL-Menu allows you to trigger a defined multiple donation to FP1 B. A total of
40 pump strokes are initiated with the activation. This function enables you to prefill
connected accessories ( tubes, distributors, etc.) with the lubricant contained in the
lubricant cartridge, especially during the initial start-up of FP1 B. However, the process
can also be aborted manually at any time.
There is no fault or error at FP1 B.
Remove the activation and programming key from the bottom of the FP1 B and place
it on the action area. The yellow LED will light up. Leave the activation and program-
ming key on the action area until FIL is displayed in the LCD. Remove the activation
and programming key from the action area. The yellow LED disappears.
Ü
The LCD flashes together with the green LED twice. The FP1 B starts donating. The
green LED lights up during each donation.
If you do not want to cancel the process: Insert the activation and programming key
into the hole provided on the underside of the FP1 B.
Ü
FP1 B dispenses 40 strokes of lubricant.
If you want to cancel the process: Place the activation and programming key on the
action area and wait until the end of a dispensing process (motor run).
Ü
CLR appears in the LCD.
Remove the activation and programming key from the action area.
Ü
FP1 B stops the FIL command.
Observe the back pressure values displayed on the LCD if they are of interest to
you.
During the dispensing process, the green LED lights up; in addition, the counterpres-
sure for the stroke is displayed in the LCD.
