EZ-PILOT STEERING SYSTEM INSTALLATION INSTRUCTIONS
2 –
EZ-Pilot System Installation
11
Preparing the vehicle
1. Park the vehicle on a hard, level surface.
2. Engage the park brake and then remove the ignition key.
3. On an articulated vehicle, install the articulation locks.
4. Remove all dirt and debris from the areas of the vehicle where the system is to be installed.
5. Open all kit boxes and lay all of the parts out on a clean workbench.
6. Check the contents of the boxes against the packing lists.
Note –
The left and right sides of the vehicle are referenced while standing behind the vehicle, facing
the normal direction of travel.
Removing the steering wheel
C
WARNING –
To avoid potentially serious personal injury or illness, and to prevent damage to
equipment, make sure that you read and understand the
chapter.
Step 1
Tilt the column fully down and then lock the
column into place.
Foot pedal tilt lever
