- 27 -
CCS-2 2001
s
et ting
the
inPut
frequenCy
If three dots "
…
" appear in the second line of the display, the cassette is in
the "
station search
" mode. Please wait until the process has finished.
Once the HF receiver has synchronised to the input signal, any offset to the
target frequency is displayed in MHz, e.g. "
– 1.8
".
If a question mark "
?
" appears in the second line of the display, there is no
input signal present. Check the configuration of the antenna system and head-
end station as well as the preceding settings of the cassette.
Bx 4A
/B
11836 -1.8
FREQ
CN 12
• Use the
buttons to position the cursor under the digit of the frequency
displayed to be set.
• Press
to set the input frequency.
• Set the frequency offset shown in the display
(e.g. "
– 1.8
") to less than
1 MHz
by varying the input frequency using the
buttons.
—> The "
CN 12
" display indicates the signal to noise ratio of the signal
received.
—> If stations are selected, the quality of the received transport stream
(level and C/N) is indicated by a status LED.
6
4
4
Status LED Tuner A
6
Status LED Tuner B
LED indicator
Indication
Green
Signal quality is good
Yellow
Signal quality is insufficient
Red
No signal
