27
Model 214B BEVELMASTER
®
92-1500 : Rev. 140425
BASIC FEED RECOMMENDATION
Use very light feed for initial cutting or until a continuous cut is established.
This is very important for longer tool bit life when cutting through flame cut or
out of square pipe ends.
Use adequate feed, .003" (.08 mm) to .006" (.15 mm) per revolution thereafter, to
establish a continuous chip cut.
If the feed is too light, only light stringer chips will be removed.
If the feed is too heavy, the drive will start to overload and the chip will start to
have a rough or torn appearance.
