12
starts heating up.
WARNING
: after about 4 minutes the control light (7)
goes off
,
which means that the boiler is ready to
produce steam.
-
On first use, or if the product did not operate for a long time, it is recommended to expel steam by using
the proper button (4) for about 2 minutes on a cloth. This will eject processing residues and limestone.
-
For using the steam, press the steam emission button (4). The button has 2 safety systems:
o
Automatic release
: steam exits only when you press the button, if you release the emission will stop.
o
Safety lock
: you can block button moving the safety lock that is in the centre of the button.
-
It is recommended to drain the remaining water after each use.
When you use the unit with steam emission, wait until the complete heating of the boiler.
CAUTION: do not fill the tank completely (max 250ml) since this operation prevent the
steam formation and causes water leaks.
ACCESSORIES
Main spout (12)
, for a long and localized jet of steam.
Assembling: Align the "I" mark on the spout (12) with the sign "II" (Figure 1) and then turn
the nozzle clockwise until it locks. To remove it, turn it counterclockwise.
Flexible hose (13)
, to expand the range.
Assembling it in the same way as the main spout. The spout (12) can be mounted on the hose (13).
Round brush (10)
, to remove encrusted dirt thanks to the bristles.
Installation: Mount the main spout (12) or the extension hose (13) and then insert the brush
(10) at the end, blocking it with the hexagonal joint (Figure III).
90° nozzle (11)
, to reach nooks and crannies.
Assembling: Mount the spout (12), the flexible hose (13) and then insert the 90° nozzle (11)
in the end, fixing it with the hexagonal joint (Figure III).
Brush (14)
, suitable for cleaning various kind of surfaces.
Same assembling as the spout. You can cover the brush (14) with the cloth (16) to improve
the performance and sensitivity of cleaning.
Windows and door brush (15)
.
Assembling: must be mounted on the brush (14).
First align (figure IV) the joints in the back of the
brush (14) with the tabs of the mirror brush (15),
then fix it (15) by framing the front tab to the body
of the brush (figure V).
REFILLING THE WATER TANK
When steam power fails, the water tank must be supplied.
-
Disconnect the plug from the electrical outlet
-
Press the steam emission button (4) until all the steam has come out.
-
Press the cap (3) and unscrew it slowly, being careful not to burn yourself with the steam coming out.
-
Allow the unit to complete cool down for 5 minutes
-
Fill in the tank with water by using the provided funnel and measuring cup, then secure the cap.
CLEANING
CAUTION Before cleaning any part of the appliance, make sure that the plug is disconnected from the
electrical outlet and that every part of the unit has cooled down.
The main body can be cleaned with a damp cloth and neutral detergent and then wiped with a dry cloth. Do
not immerse the product in water or other liquids.
The accessories can be washed under the jet of tap water; dry them completely before re-assembling them to
the unit.
