16
HCV 10D35 DAB
ENGLISH
INSTALLATION
ATTACHING THE STAND (See Illustrations Below)
A.
Turn the unit over as shown below, and align the mounting blocks on the top of the stand, with the mounting openings located on
the bottom of the main unit. Once in place, the 4 mounting tabs on the stand will align with the 4 rectangular mounting slots
located on the bottom of the unit. Make sure the mounting tabs are lined up with the slots, and slide the stand towards the front
of the unit until the mounting stand it is fully inserted, and locked in place. Make sure the base is locked firmly in place, so it
does not come off.
B.
To remove the stand, use both hands to hold the stand, and using two fingers, lift the two locking tabs marked with arrows to
unlock the base. Slide the stand towards the back of the unit to unlock. When the stand is in unlock position, pull the stand
upward to remove it.
FOR WALL MOUNTING (STAND MUST BE REMOVED)
It’s important to be sure there are no electric, gas or water lines located behind the wall where you are attaching the unit. We
recommend having this speaker professionally installed. Use the included wall mounting accessories and template to attach the
sound bar to the wall.
1. Use the supplied wall mounting instruction sheet to make marks on the wall for the plastic anchors. Make sure the marks are
level before drilling;
2. Drill 1/4” holes on the marks;
3. Insert the included plastic anchors into the holes until they are flush with the wall;
4. Screwing the 2 included flat head screws into the plastic anchor holes and tighten the screws;
5. When the screws are tightened, the screw heads should be about ¼” away from the mounting wall. Line up the keyhole slots
located on the back of the main unit with screws in the wall;
6. Hang the unit onto the screws.
WALL MOUNT PREPARATION
To mount the unit on the wall
CAUTION:
• Be very careful to prevent the unit 2.1 kg (4.2 bs.) from falling when mounting on the wall.
• Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The unit may fall.) If unsure,
consult a qualified service technician.
• Use the supplied mounting screws.
