TRENDnet TPE-P521ES, User Manual, Page: 49 / 68

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPE-P521ES
46
Configure PoE settings
PoE > PoE Configuration
1. Log into your switch management page (see “ Access your switch management page ”
on page 7).
2. Click on PoE and click on PoE Configuration.
3. Review the settings for each port. Next to each port entry, click Apply to save the
settings.

Port - Indicates the port with a specific PoE status and that you are configuring.
Note: You can Enable the row labeled ALL to apply settings to all ports.

Admin - To activate or deactivate PoE on a specific port, select Enable or
Disable. By default the PoE feature is enabled on all switch ports.

Status - The PoE port status is given as follows:
o
Power ON - The port is supplying PoE power.
o
Power OFF - The port is not supplying PoE power.

Classification - The PoE class is indicated the class of the PD. N/A is displayed
when the port is not supplying power.

PowerLimit – Indicates the power limit by class or power limit defined by the
user.

UserDef – After User Define is selected in the PowerLimit cell, users can define
the maximum power consumption for a specific port.
Note: The User Defined power limit ranges between 1.0 and 18.0 watts.

Legacy Support – When Legacy Support is enabled, the port sends out Passive
PoE requirements to the device connected to the port.
Note: Doing so, may damage the device connected to the devices’ ports.

Power (W) - Indicates the Power in watts that the port is supplying power to
the PD.

Voltage (V) - Indicates the Voltage in volts as measured at the port when the
port is supplying power to the PD.

Current (mA) - Indicates the Current in milliamps that the port is supplying to
the PD.
NOTE: The configured settings are only applied to the switch’s temporary memory and
will be lost upon the next power-cycle. Please follow these next steps to save the
configurations to the switch’s NV-RAM to ensure the settings will remain throughout
power-cycles and reboots:
1. From the menu on the left: click on Save, then click the blue button Save
Settings to Flash.
2. Click Continue to return to the Web Configuration of your switch.