TRENDnet TL2-FG142, User Manual

Page: 90 / 134

© Copyright 2019 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TL2-FG142
85
Queue
Shaper Rate Controls the rate for the queue shaper. The default value is 500. This
value is restricted to 100-1000000 when the "Unit" is "kbps", and it is
restricted to 1-3300 when the "Unit" is "Mbps".
Queue
Shaper Unit Controls the unit of measure for the queue shaper rate as "kbps" or
"Mbps". The default value is "kbps".
Queue
Shaper Excess Controls whether the queue is allowed to use excess bandwidth.
Queue
Scheduler
Weight Controls the weight for this queue. The default value is "17". This value is
restricted to 1-100. This parameter is only shown if "Scheduler Mode" is
set to "Weighted".
Queue
Scheduler
Percent Shows the weight in percent for this queue. This parameter is only
shown if "Scheduler Mode" is set to "Weighted".
Port Shaper
Enable Controls whether the port shaper is enabled for this switch port.
Port Shaper
Rate Controls the rate for the port shaper. The default value is 500. This value
is restricted to 100-1000000 when the "Unit" is "kbps", and it is
restricted to 1-3300 when the "Unit" is "Mbps".
Port Shaper
Unit Controls the unit of measure for the port shaper rate as "kbps" or
"Mbps". The default value is "kbps".
Button
Click to save changes.
Click to undo any changes made locally and revert to previously saved values.
Click to undo any changes made locally and return to the previous page.
4.3.29.5 Port Shaping
This page provides an overview of QoS Egress Port Shapers for all switch ports.
The displayed settings are:
Items Description
Port The logical port for the settings contained in the same row.
Click on the port number in order to configure the shapers.
Mode Shows "disabled" or actual queue shaper rate - e.g. "800 Mbps".
Qn Shows "disabled" or actual port shaper rate - e.g. "800 Mbps".
QoS Egress Port Scheduler and Shapers Configuration
This page allows you to configure the Scheduler and Shapers for a specific port.