© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-831DR
52
When adding static routes, they will appear in the Static Route List. To delete a route,
check the box in the No. column to select which routes to delete, then click Delete.
Enable Dynamic Routing
Advanced > Setup > Routing
You may want set up your router to route computers or devices on your network to
other local networks through other routers. Generally, different networks can be
determined by the IP addressing assigned to those networks. Generally speaking and for
the case of an example, your network may have 192.168.10.x IP addressing and another
network may have 192.168.20.x IP addressing and because the IP addressing of these
two networks are different, they are separate networks. In order to communicate
between the two separate networks, static routing needs to be configured. Below is an
example diagram where routing is needed for devices and computers on your network
to access the other network. If you have other routing devices that support dynamic
routing protocol, you can enable these routing protocols on your router to learn and
automatically generate the routes needed between these networks.
Note: Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see “
Access your router management page
on page 10).
2. Click on Advanced and click on Setup, then click on Routing.
3. Review the Routing section. To save changes to this section, click Save when finished.
Commit your changes to the router by clicking on Apply/Discard Changes in the left-
hand menu, and click Apply & Reboot.
Enable RIP: Click the drop-down list to enable or disable RIP dynamic routing
protocol.
RIP mode: Depending on which RIP version dynamic routing protocols your other
routing devices support, click the appropriate version v1 or v2.
Note: If selecting RIP v2, this requires basic password authentication between
routing devices using this protocol. The password must match on all routing
devices connected in order successfully exchange routing information.
You can also view the current routing table under Routing Table.
