TRENDnet TEW-826DAP, User Manual, Page: 25 / 72

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-826DAP
22
To apply captive portal authentication to a wireless SSID, under 2.4G or 5G, select which
SSIDs captive portal authentication should be applied, then click Save at the bottom of
the page to save the settings.
Note: The SSIDs must be enabled and configured under Wireless > 2.4G or 5G to be
assigned. If using Captive Portal authentication, it is recommended to set the
Authentication method to None in the wireless SSID settings since captive portal
authentication will be used instead. If the Authentication Method is left enabled, the
users will need to authenticate twice, once with the authentication method defined and
also captive portal authentication.
Once you are done with all your configurations, click on the Save button then click on
the flashing Apply/Discard button located on the top left section, and click Save &
Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.
Redirect URL
1. Log into your management page (see “ Access the management page ” on page
8).
2. Click on the System tab and click Captive Portal.
3. Choose the Captive Portal mode Redirect URL.
First, enable Captive Portal, enter the URL/website to redirect users and set an
authentication timeout value. Then click Save at the bottom of the page to save the
settings.

Redirect – Enables the redirect URL captive portal function.

Redirect URL – This is the website or URL guest users will be
automatically redirected after connecting to your wireless network
through your captive portal page. (e.g. https://www.trendnet.com)

Authentication Timeout – This is the session time period (minutes) which
users are allowed to be logged in to your wireless network. Once the time
expires, users will automatically logged and will need to log back in
through the captive portal page again in order to reconnect to your
wireless network. It is recommended to set a value to ensure
authentication sessions are closed after a certain time period.