TRENDnet TEW-734APO, User Manual

Page: 30 / 65

© Copyright 2015 TRENDnet. All Rights Reserved.
29
TRENDnet User’s Guide
TEW-734APO
2. Click on Tools , and click on System Log . Click Apply to save settings.

Enable Remote Syslog Server: Check this option to enable DMZ

IP Address: enter the IP address ( e.g. 192.168.10.250 ) of the external log server
to send

Port: Enter the port used on your log server.
View your log
You may want send your router log to your e-mail address or to an external log server
(also known as Syslog server) so you can check it periodically while away from home.
You may also want to only see specific categories of logging.
1. Log into the management page (see “ Access the management page ” on page 9).
2. Click on Tools , and click on System Log . Click Apply to save settings.

Time: Displays the date and time of the log entry. If the time is inaccurate, make
sure to set the router date and time correctly. (See “ Setting time ” on page 51)

Source: Source of the log entry

Message: Displays the log message.

Refresh: Click to refresh the displayed log entries

Clear: Click to clear all current log entries
Ping Watchdog
You may want to expose a specific computer or device on your network to the Internet
to allow anyone to access it. Your router includes the DMZ (demilitarized zone) feature
that makes all the ports and services available on the WAN/Internet side of the router
and forwards them to a single IP address (computer or network device) on your
network. The DMZ feature is an easy way of allowing access from the Internet however,
it is also very
insecure method.
1. Log into the management page (see “ Access the management page ” on page 9).
2. Click on Tools , and click on Ping Watchdog . Click Apply to save settings.

Enable Ping Watchdog: Check this option to enable option

IP Address to Ping: Enter the IP address of the remote unit to ping

Ping Interval: Enter the time interval in seconds to ping the remote unit

Startup Delay: Enter the startup delay time in seconds to prevent the reboot
before the access point is initialized

Failure Count To Reboot: Enter the count value of when the access point will
reboot automatically