TRENDnet TEG-S50ES, User Manual, Page: 26 / 65

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEG-S50ES
23

Link Aggregation List lists the current active trunking groups and their
respective ports. Clicking Delete removes the group.
NOTE: The configured settings are only applied to the switch’s temporary memory and
will be lost upon the next power-cycle. Please follow these next steps to save the
configurations to the switch’s NV-RAM to ensure the settings will remain throughout
power-cycles and reboots:
1. From the menu on the left: click on Save, then click the blue button Save
Settings to Flash.
2. Click Continue to return to the Web Configuration of your switch.
Mirroring
Configure port mirror settings
Network > Mirroring
Port mirroring allows you to monitor the ingress and egress traffic on a port by having
the traffic copied to another port where a computer or device can be set up to capture
the data for monitoring and troubleshooting purposes.
1. Log into your switch management page (see “ Access your switch management page ”
on page 7).
2. Click on Network, and click on Mirroring.
3. Review the settings. Click Apply to save changes.

Status – Click the drop-down and list and select one of the following options:
o
Enable - This parameter activates the Port Mirroring feature and the
rest of the configuration parameters become active on the page.
o
Disable - This parameter de-activates the Port Mirroring feature and
the rest of the configuration parameters become inactive on the page.

Mirror Target Port – Click the drop-down and list and select the port to send
the copied ingress/egress packets/data. (e.g. Computer or device with packet
capture or data analysis program.)
Check the port to monitor or copy inormation from. (Source)
To copy data received on a specific port, select Ingress as the Frame Type and check the
port number(s) under the section or you could click All to copy data received on all
ports.
To copy data transmitted on specific port, select Egress as the Frame Type and check
the port number(s) under the section or you could click All to copy data received on all
ports.