© Copyright 2022 TRENDnet. All Rights Reserved.
74
TRENDnet User’s Guide
Multi-Gig Web Smart Switch Series
1. Log into your switch
management page (see “
Access your switch management page
on page 5).
2. Click on
Tools
, click on
Firmware Upgrade
.
3. Make sure your TFTP server is running and note the IP address of your server and
firmware file name. The TFTP server should be in the same IP subnet as the switch.
Note:
It is recommended to that the firmware file (.hex) is placed in your TFTP server
root directory.
5. Review the settings. Click
Apply
to start the firmware upgrade.
•
Upgrade Method:
Select TFTP to update the firmware via TFTP
•
Partition:
Select which image to update the firmware
•
TFTP Server:
Enter the IP address of your TFTP server.
•
File Name:
Enter the firmware filename with extension.
(.hex)
6. Click
Apply
to start the firmware upgrade.
Dual Image
Tools > Firmware > Dual Image
Select the image to bootup on your switch from the next power cycle.
1. Log into your switch
management page (see “
Access your switch management page
on page 5).
2. Click on
Tools
, click on
Firmware
, and click on
Dual Image
.
3. Review the settings. Click
Apply
to apply the changes and
Save
to save the changes.
•
Active:
Displays the current Partition Image that is running on the switch. You
may select a different partition to boot up with here.
•
Flash Partition:
Name of partition
•
Status:
Displays the status of a partition. A partition that is currently running
will display
Active,
while one that is in standby will display
Backup.
•
Image Name:
Firmware name of the partition
•
Image Size:
Size of the firmware that is loaded on each partition
•
Created Time:
When the firmware was loaded onto the partition
Summary of Contents for TEG-3102WS
Page 1: ...TRENDnet User s Guide Cover Page...
Page 95: ......
