TRENDnet Powerline 1300 AV2 Adapter with Built-in Outlet, User Manual

Page: 4 / 26

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPL-423E / TPL-423E2K
2
MIMO with Beamforming Technology
Multiple Input Multiple Output (MIMO) Powerline with Beamforming technology uses
live, neutral, and ground wires to increase performance between adapters.
Expandable
Use up to 8 adapters on a single Powerline network
Easy Installation
TRENDnet adapters auto-connect out of the box
128-bit AES Encryption
Powerline communication is protected with 128-bit AES encryption
Note:
* Maximum of 8 adapters (nodes) recommended for streaming video across your
network.
** 1.3Gbps is the maximum theoretical Powerline data rate when connected to another
Powerline 1300 device. Data throughput may vary by circuit wire conditions.
*** Powerline communication works on a single electrical system. (Usually controlled by
a single distribution panel). Power strip, GFCI outlets, and AFCI circuit breakers may
degrade Powerline network signals.
Product Hardware Features
Power Save Mode : The Powerline adapter will automatically going into standby mode
to reduce power usage when there is no network traffic for more than 10~20 minutes.
All LEDs are going off. It can be wake up automatically when the network traffic is
coming again. It will take a couple of seconds to wake up and resume back to full speed
of service.
Button Action Function
Sync
Press for 2 seconds
Begins synchronization session. The POWER LED will
begin to blink for 2 minutes. Press the Sync button on
additional adapters within the time frame to
synchronize to the powerline network.
Press for 10 seconds
Generates a new random network name and encryption
key (All LEDs will turn off and on again).
Reset Press for 1 second
Resets device to factory defaults settings (All LEDs will
turn off and on again).
Note: Will reset to the factory default private network
name “HomePlug AV”.
Network Port
LED Indicators
Sync Button
Reset Button
Built-in Outlet