40
IQ23x Series Controllers Installation Instructions TG200539 Issue 2 , 23-Feb-2012
IQ23x
Installation Instructions
Please send any comments about this or any other Trend technical publication to [email protected]
© 2012
Honeywell Technologies Sàrl, ECC Division. All rights reserved. Manufactured for and on behalf of the Environmental and Combustion Controls
Division of Honeywell Technologies Sàrl, Z.A. La Pièce, 16, 1180 Rolle, Switzerland by its Authorized Representative, Trend Control Systems Limited.
Trend Control Systems Limited reserves the right to revise this publication from time to time and make changes to the content hereof without obligation
to notify any person of such revisions or changes.
Trend Control Systems limited
Albery House, Springfield Road, Horsham, West Sussex, RH12 2PQ, UK. Tel:+44 (0)1403 211888 Fax:+44 (0)1403 241608 www.trendcontrols.com
Trend Control System USa
6670 185th Avenue NE, Redmond, Washington 98052, USA. Tel:(425) 869-3900 Fax:(425) 869-8445 www.trend-americas.com
31
Check Trend lan and Internetwork Sections
Do separate check fo each Lan/Internetwork segment
32
Replace Cover
33
Close panel
34
Reconnect I/o Supply
35
Configure
if required
36
Test System
Weee Directive:
At the end of their useful life the packaging, product,
and battery (if fitted) should be disposed of by a
suitable recycling centre. Do not dispose of with
normal household waste. Do not burn.
15 DISpoSal
b
TX
(yellow)
a
RX
(yellow)
c
OK
(green)
Node Faulty
Check baud rate
. Check
network cabling for short circuits
with a multimeter (NOT Megger)
Network Address Invalid
0, 2, 3 or >119
OK
OK
node
Power up other nodes until
faulty node is found (OK
). Correct fault.
TMN type board
shown
Check data sheet
for location of
LEDs on other
boards
node
node
LAN
LAN
14 InSTallIng an aUxIlIaRy InTeRnal noDe BoaRD FRoM a ReplaCeD
ConTRolleR
(continued)
replace 5 screws
Node Installation Instructions
Node Installation Instructions
