Traxxas E Revo Brushless Edition 56087, Owner'S Manual

Page: 24 / 38

24 • E-REVO BRUSHLESS
MOTORS AND GEARING
CAUTION: Read before operating your model with 65+mph
gearing!
• The 24/54 ratio for use with 6S LiPo batteries is designed
for maximum speed on smooth surfaces only, with steady
acceleration to full throttle.
• Do not use this gear ratio for general driving.
• Avoid repetitive starting and stopping.
• Do not use the 24/54 ratio with NiMH batteries or low-capacity
LiPo batteries. 5000mAh LiPo batteries are recommended.
• Allow the motor to cool between runs, and monitor motor
temperature.
• Do not use the 24/54 gear ratio for off-road running or
overheating and damage may result.
• Do not allow the motor temperature to exceed 200° F or damage
and motor failure may result. To accurately monitor motor
temperature and prevent overheating, a telemetry temperature
sensor (part #6521) is included with your model. The sensor is
installed on the motor to continually monitor temperature as you
drive. See page 31 for more information on real-time telemetry
and TQi advanced tuning.
Adjusting Gear Mesh
Incorrect gear mesh is the most common
cause of stripped spur gears. Gear mesh
should be checked and adjusted anytime
a gear is replaced. Access the gears by
removing the single screw on the top
gear cover.
To set the gear mesh, cut a narrow strip of
notebook paper and run it into the gear
mesh of the motor. The motor is mounted
to an aluminum motor mount.
Loosen the single motor mount
screw with the provided 3mm
wrench to slide the motor
mount. Slide the motor and
pinion gear into the spur gear.
Retighten the motor mount
screw and then remove the
strip of paper. You should be
able to run a fresh strip of paper
through the gears without binding them.
Gearing Compatibility Chart:
The chart below shows a full range
of gear combinations. This does NOT
imply that these gear combinations
should be used. Over-gearing
(bigger pinions, smaller spurs) can
overheat and damage the motor
and/or speed control.
BASIC TUNING ADJUSTMENTS
54 56 58 62 65 68
12 4.50 4.67 4.83 5.17 5.42 5.67
13
4.15 4.31 4.46 4.77 5.00 5.23
14 3.86 4.00 4.14 4.43 4.64 4.86
15 3.60 3.73 3.87 4.13 4.33 4.53
16 3.38 3.50 3.63 3.88 4.06 4.25
17 3.18 3.29 3.41 3.65 3.82 4.00
18 3.00 3.11 3.22 3.44 3.61 3.78
19 NR NR 3.05 3.26 3.42 3.58
20 NR NR NR 3.10 3.25 3.40
21 NR NR NR NR 3.10 3.24
22 NR NR NR NR NR 3.09
23 NR NR NR NR NR DNF
24 NR NR NR NR NR DNF
25 NR NR NR NR NR DNF
Pinion Gear
Spur Gear
Stock gearing
B
Optional included gearing (4S LiPo)
B
Recommended gearing
for 4S LiPo only
Not recommended
Does not fit
Recommended gearing
for all battery types
Motor Mount
Screw
Strip of Paper
Speed 35+ mph 40+ mph* 50+ mph
65 mph
& Beyond
Pinion/Spur 18/65 18/54 18/65 24/54 **
Battery
Twin 7-Cell NiMH
(14 cell total)
Twin 2S LiPo
(4S total)
Twin 3S LiPo
(6S total)
Twin 3S LiPo
(6S total)
Nominal Voltage 16.8V 14.8V 22.2V 22.2V
mAh 4000+ mAh 5000+ mAh 5000+ mAh 5000+ mAh
Skill Level
Your Battery Selection and Pinion Gear
Selection Determines Your Speed.
How Fast Do You Want To Go?
For Expert Drivers For Expert Drivers
*with included optional gearing
**optional gearing (not included)
Model #56087-3