E-REVO BRUSHLESS • 15
TRAXXAS STABILITY MANAGEMENT (TSM)
Traxxas Stability Management or TSM
allows you to experience all the speed
and acceleration that was engineered
into your Traxxas model by helping
you to maintain control of the vehicle
in low-traction situations. TSM helps provide straight ahead full-
throttle acceleration on slippery surfaces, without fishtailing, spinouts,
or loss of control. TSM also dramatically improves braking control.
High speed cornering and control is also made possible as TSM
makes corrections for you, without intruding on your fun, or creating
unexpected side effects.
The Multi-Function knob on
the TQi transmitter has been
programmed to control TSM. The
recommended (default) setting
for TSM is to rotate the knob to
the 12:00 position (the zero mark
on the dial).
Turn the knob clockwise to
increase assistance; turn the knob
counterclockwise to decrease
assistance. Turn the
knob counterclockwise to its
stop to turn TSM completely off.
Note:
TSM is deactivated
automatically when driving or
braking in reverse.
When driving on surfaces with some traction, decrease the TSM
setting to allow the vehicle to feel more “loose” for power sliding,
drifting, and so on. On surfaces with very little traction (loose dirt,
smooth concrete, ice/snow), increase TSM to maximize acceleration
and control.
Drive with TSM on and off to test how it is making your control of the
vehicle easier and more precise. For more information, visit Traxxas.
com/tsm.
Note:
TSM must be completely turned off while adjusting steering
trim.
SETTING UP THE ANTENNA
The receiver antenna has been set up and
installed from the factory.
When reinstalling the antenna, first slide
the antenna wire into the bottom of the
antenna tube until the white tip of the
antenna is at the top of the tube under the
black cap. Insert the base of the tube into
the antenna post. Take care not to crimp the
antenna wire. Slide the crimp nut over the
antenna tube and screw it onto the antenna
post. Use the supplied tool to tighten the
crimp nut on the post just until the antenna
tube is securely in place. Do not overtighten
or crush the antenna wire against the
chassis.
Do not bend or kink the antenna
wire! See the sidebar for more information.
Do not shorten the antenna tube.
To prevent loss of radio range
do not kink or cut the black wire,
do not bend or cut the metal tip,
and do not bend or cut the white
wire at the end of the metal tip.
Correct
No
No
No
TRAXXAS TQ
i
RADIO SYSTEM
Antenna
Tip
Antenna
Tube
Antenna
Wrench
Antenna
Crimp Nut
Antenna
Post
Recommended setting
Decrease
assistance
Increase
assistance
TSM off
Summary of Contents for E Revo Brushless Edition 56087
Page 1: ...MODEL 56087 3 OWNER S MANUAL...
Page 37: ......
