28
STEP G-4
Slide a rear wheel over the stub axle, turn until it locks into the wheel. Secure
the wheel with a 4mm locknut. Repeat steps G-2 through G-4 for the
remaining rear wheel.
STEP G-6
Liberally coat the front axles with silicon grease. Insert a front axle through
the oilite bushings in a steering block. Slide a 5x8x0.5mm teflon washer over
the front axle. Insert an axle pin through the hole in the axle.
STEP G-5
Locate the front axles, the remaining two axle pins and hex hubs, two
5x8x0.5mm teflon washers and two 4mm locknuts.
BANDIT:
The Bandit front axles are shorter than the ones pictured. The Bandit does not
require hex hubs in the front.
STEP G-3
Slide a hex hub over the stub axle, aligning the stub axle pin with the slots in
the hex hub.
STEP G-7
Slide a hex hub onto the front axle, aligning the axle pin with the slots in the
hex hub.
BANDIT:
Skip to Step G-8. The Bandit does not require the hex hub.
