22
STEP E-19
Position the speed control mount on the chassis as shown. Secure it with two
3x10 washerhead self-tapping screws.
RECEIVER:
STEP F-1
The receiver is part of the radio system and is not included in the kit. If you
are using a Traxxas receiver, fasten the tabs on the receiver to the posts
molded in the left side of the chassis. Use two 3x6mm washerhead self-
tapping screws. Mount all other receivers by using double-sided servo tape.
Clean the surfaces of the receiver and the chassis with rubbing alcohol
before applying the servo tape. Route the antenna wire under the receiver.
STEP F-2
Insert the antenna wire through the antenna tube, and then insert the
antenna tube into the slot in the chassis. Do not cut the antenna wire to
shorten it. The antenna tube and the antenna tip are in the instruction bag.
STEP F-3
Fold the excess antenna wire over the end of the antenna tube and secure it
with the antenna tip.
STEP E-18
Place the battery hold-down plate over the posts and secure it with the two
body clips.
