Wall Thermostat - Gas/Pellet
Part # 99300650
Page 1 of 2
10850 117th Place N.E. Kirkland, WA 98033
Printed February 3, 2003
CHECK CONDITION OF SHIPMENT
Upon receipt of this kit, check the condition of the packaging. Damage to the package should be noted on the carrier's freight
receipt. Any damage claims as a result of shipping must be handled through the shipper. Travis Industries will provide assistance
in resolving shipping claims or replacing items not included in the package. Please report any missing items immediately.
COMPATIBILITY
• All Travis Gas Stoves & Inserts • Newport (Avanti) Pellet Stoves & Inserts • Pioneer (Heritage Bay) Pellet Stoves & Inserts
ITEMS NEEDED FOR ASSEMBLY
• Standard Screwdriver
• Additional tools may be required for laying the thermostat wire
• You may need additional tools to access the on/off switch on certain gas heaters - refer to the instructions in the owner's manual.
PACKING LIST
• Thermostat • Thermostat wire (25' long) • 2 Screws (for attaching the thermostat to wall)
INSTALLATION INSTRUCTIONS
!
This kit must be installed by a qualified technician.
!
Do not connect 110 VAC to the gas control valve or on/off switch on gas heaters or the thermostat posts on pellet heaters.
Gas Heater Installation
Remove the on/off wire on the lower post of the
on/off switch and attach it to the upper post.
Back of on/off switch
Red & brown wires
leading to the gas
control valve.
a
b
Connect the thermostat wires to the lower two posts
on the on/off switch (orientation does not matter).
Pellet Heater Installation
Attach the thermostat wire to the
circuit board.
b
Swing the
panel
open.
c
Thread the thermostat wire, quick-
connect end first, through the hole in the
rear panel.
a
Phillips
Screwdriver
Open the hopper lid and remove the
screw holding the right panel in place.
d
Attach the quick-
connects to the
thermostat posts
on the circuit
board (orientation
does not mater).
Pull on the thermostat
wire to allow just enough
slack to allow the right
side panel to open.
