Installation (for qualified installers only)
7
© Travis Industries
4080123
100-01174_002
Installation Warnings
•
Failure to follow all of the requirements may result in property damage, bodily
injury, or even death.
•
This heater must be installed by a qualified installer who has gone through a
training program for the installation of direct vent gas appliances.
•
This appliance must be installed in accordance with all local codes, if any; if not,
follow ANSI Z223.1 and NFPA 54(88).
•
In Manufactured or Mobile Homes must conform with Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280, or, when such a
standard is not applicable, the Standard for Manufactured Home Installations,
ANSI/NCSBCS A225.1. This appliance may be installed in Manufactured Housing
only after the home is site located.
•
The heater is designed to operate on natural gas, or propane (LP).
•
All exhaust gases must be vented outside the structure of the living-area.
Combustion air is drawn from outside the living-area structure.
•
Notify your insurance company before hooking up this heater.
•
The requirements listed below are divided into sections. All requirements must
be met simultaneously. The order of installation is not rigid – the qualified
installer should follow the procedure best suited for the installation.
Packing List
•
Top Convection Deflector (with screws)
•
Propane Conversion Kit
•
Log Set
•
"Fireplace Altered" tag (attach to the fireplace)
•
FPX Face Brackets (see pg. 11 for details)
Additional Items Required
•
Faceplate
•
6-5/8" to 3" & 4" Co-Linear Adapter - with flashing (Travis part # 98900124)
•
3" and 4" Diameter Gas Liner
•
Direct Vent Cap (Simpson Duravent Part # 991)
•
Gas Line Equipment (shutoff valve, pipe, etc.)
Items Packed with the Face
•
Face with attachment hardware and cove covers (if necessary)
•
Face Installation Instructions
Order of Installation
1
Install the Top Convection Deflector (see page 8).
2
If the heater is to use propane, install the propane conversion kit (see page 36).
3
Install gas line into the fireplace (do not connect to unit).
4
Position the heater.
5
Connect the gas line and gas vent to the appliance.
6
Install the optional surround panels and trim. Attach the on/off switch.
7
Follow the instructions under "Finalizing the Installation" on page 24.
