Traub TNL20, Operating Instructions Manual

Page: 42 / 74

42
Transport and installation
TNL20
DTE022DE - 24.06.2021
Transporting the machine
Unloading and transporting the machine by forklift
Danger from falling machine/parts
No persons are allowed to remain under suspended loads!
Danger from tilting of the machine!
If the machine is transported by forklift, it must be secured against
tipping!
Attention must be paid to the center of gravity of the machine.
• Non-slip mats should be placed on the fork arms when transporting the
machine.
• Insert the fork arms in the openings on the control cabinet side of the ma-
chine and unload it from the truck.
When setting the machine down, ensure that the fork arms are not tilted,
otherwise the planks will break.
It is advisable to remove the planks from the machine before trans-
porting it further.
• For this purpose, lift the machine slightly with the fork lift truck and support
it as appropriate.
• Take out the screws in the planks and remove the planks.
• Next, screw the 4 adjusting screws (1) back in and lightly counter them with
the hex head lock nut (2) (the adjusting screws can be found in the accesso-
ries in the chip conveyor or the chip pan).
2
1