TRASSIR TR-D4D2, User Manual

Page: 117 / 151

CHAPTER 3. TRASSIR IP CAMERA CONFIGURATION
Press Clear to remove the current border.
3.3.6.4 «Intrusion» tab
NOTE.
Before starting the setup, make sure that the camera is installed correctly for the proper
operation of the video analytics module. Check Supplement E. IP Camera placement or
camera installation recommendations.
Go to the Intrusion tab to open the intrusion detection settings.
Specify the zone one video using left mouse button. The following settings are available
for each zone:
Setting Description
Sensitivity Specify the detector's sensitivity, from 0 to 4 . The higher the value is, the more
sensitive is the detector.
Trigger blink Set the flag so the specified zone start flashing on video when the detector is
triggered.
Scene mode Select the detector's operation mode: Indoor or Outdoor .
Direction Set the direction of the specified area crossing at which the alarm event will be
triggered:

Enter – the detector will trigger when an object appears in the area

Left — the detector will trigger when an object leaves the area;

Both — the detector will trigger when moving in both directions.
Press Save to save the settings.
User manual for TRASSIR IP cameras 117