OPERATING AND INSTALLATION INSTRUCTIONS
iGAZERSR33HD-B
Battery Powered
Photo Eyes
DESCRIPTION:
The iGAZERSR33HD-B is an infrared photo eye used for safety detection in automated gates. The
RX photo eye is hard wired to the gate operator with 12/24 VAC/DC power. The TX photo eye is
battery powered with 4 AAA 1.5 V batteries. The photo eyes are convenietly adjustable - horizontally
+\- 90 degrees and vert\- 15 degrees. Due to the sealing gasket within the steel casing, the
photo eye is resistant to the elements at an IP rating on 55.
ASSEMBLY INSTRUCTIONS
Attach the photo eyes approximately 15-24 inches from the ground, and at a maximum distance of
4 inches from the impact zone fo the gate. The photo eyes should be placed close enough to the
gate to detect any obstruction caused at the border of the impact area. In the case of swing gates,
the 4 inch eistance is to be measured with the door in the open position. It is recommended to
install both the transmitting and receiving photo eye on the same axis.
TECHNICAL SPECIFICATIONS:
Power
supply
12/24
VAC/DC
Operating
Temperature
5° to 140°F
RC consumption
47 mA at 12 VAC; 35 mA (inactive)
22 mA at 12 VDC; 16 mA (inactive)
48 mA at 24 VAC; 36 mA (inactive)
24 mA at 24 VDC; 18 mA (inactive)
TX Battery Type
6V, 4AAA
Battery Life (Low power)
24 months
Battery Life (High power)
14 months
Range
(Low)
26
feet
Range
(High)
49
feet
Wave
length
950
nm
Modulation
1.33
KHz
Current commutable by the relay
1 A at 24 V
Rating
IP
55
Load
33
feet
ATTENTION:
Transmitter Solutions is not responsible for wrong
connections or damages to persons or things. The
installation must be done by qualified people.
GASKET MOUNTING:
Make sure the rubber gasket is placed in the channel
and is flush with the edge of the metal housing. It is
important to ensure the gasket is in place on the back
of the photo eye in order for the housing to be sealed
correctly. Once the gaskets are in place, the housing
can be secured with the screws provided.
V.8.2.17
