Transition M/GE-T Series, User Manual, Page: 8 / 11

Transition Networks, Inc. M/GE-T-xxx-01 User Guide
33516 Rev. B https://www.transition.com Page 8 of 11
Technical Specifications
For Transition Networks M/GE-T-xxx-01 or equivalent:
Standards IEEE802.3, 802.3z, 802.3ab
Regulatory Compliance for Emission CISPR22/EN55022 Class A, FCC Class A
Regulatory Compliance for Immunity EN55024
Safety Compliance Unit: CE Mark
Data Rate
1000Mbps
Power Consumption 0.2A@12VDC, 2.4 Watts (2.6 Watts on datasheet)
Power Source 12VDC external wall mounted power supply that is UL Listed
Power Input 12VDC coax barrel input (7.5~13.9VDC)
Copper port RJ-45
Fiber Port connector ST, SC, and SFP
Jumbo Frames (Ethernet port) Supported up to 13,312bytes
DIP Switches / jumpers None; fixed configurations
Dimensions Width: 1.8" [46 mm] x Depth: 3.3" [85 mm] x Height: 0.85" [22 mm]
Weight 2 Lbs. (0.90 Kg.)
Operating Temperature 0 to +50 degree C
Storage Temperature -15 to +65 degree C
Altitude 0-10,000 feet
Operating Humidity 5% to 95% (non-condensing)
MTBF (unit): Greater than 250,000 MIL-HDBK-217F Hours.
Greater than 687,500 Bellcore Hours
MTBF (bundled with typical Greater than 41,660 MIL-HDBK-217F Hours
50,000 hour power supply) Greater than 114,580 Bellcore Hours
Warranty Lifetime
For current information on the M/GE-T-xxx-01, view the online user guide at
https://www.transition.com/ .
The fiber optic transmitters on this device meet Class I Laser safety requirements per IEC-825/CDRH standards and comply with 21
CFR1040.10 and 21CFR1040.11.
WARNING: Visible and invisible laser radiation when open. Do not stare into the beam or view the beam directly with optical
instruments. Failure to observe this warning could result in an eye injury or blindness.
WARNING: Use of controls, adjustments or the performance of procedures other than those specified herein may result in
hazardous radiation exposure.
IMPORTANT: Copper based media ports such as Twisted Pair (TP) Ethernet, USB, RS232, RS422, RS485, DS1, DS3, Video Coax, etc.,
are intended to be connected to intra-building (inside plant) link segments that are not subject to lightening transients or power
faults. Copper-based media ports such as Twisted Pair (TP) Ethernet, USB, RS232, RS422, RS485, DS1, DS3, Video Coax, etc., are NOT
to be connected to inter-building (outside plant) link segments that are subject to lightening transients or power faults.