Transition Networks
SPS-2460-xx Power Supply User Guide
33455 Rev. B
Page 5 of 9
Supplying Power to the SPS-2460-xx
CAUTION: TURN OFF the main power source before making connection to the SPS-2460-xx external power
supply. Failure to observe this caution could result in damage to or failure of the SPS-2460-xx power supply and
any attached device.
WARNING: ONLY qualified person should connect power to the SPS-2460-xx power supply. Failure to observe
this warning could result in an electrical shock or equipment damage.
To supply power to the SPS-2460-xx, see the drawing below and do the following:
1.
Turn external power source OFF.
2.
Connect the ground terminal of the power source to the ground terminal on the SPS-2460-xx power supply.
3.
Connect the power wires to the DC (
+
) and (
-
) terminals on the main external power panel (note polarity).
4.
Loosen the two screws on the keyed Euro block (Terminal block).
5.
Insert the positive (+) power wire from the main power into the Euro block (note polarity on power supply)
and tighten the screw to secure the wire.
6.
Insert the negative (-) power wire from the main power into the Euro block (note polarity on power supply)
and tighten the screw to secure the wire.
7.
Orient the Euro Block as shown below and then insert it into the Euro Header on the power supply.
8.
Tighten the two screws to secure the Euro block to the Euro header on the power supply.
9.
Turn ON the external power source.
