Transition Networks
SM24T6DPA Web User Guide
33664 Rev. B
Page
15
of
26
Web-based Management
The switch default values are listed below:
IP Address
192.168.1.77
Subnet Mask 255.255.255.0
Default Gateway
192.168.1.254
Username
admin
Password
admin
After the managed switch has been configured in the CLI via the switch’s serial interface, you
can browse it. Type 192.168.1.77 in the address row in a browser; the following screen
displays, prompting you for a username and password.
The default username and password are both “
admin
”. For first time use, enter the default
username and password, and then click the
Login
button.
The login process now is complete.
Making Network Connections
Connecting Network Devices
The switch is designed to be connected to 10, 100 or 1000Mbps network cards in PCs and
servers, as well as to other switches and hubs. It may also be connected to remote devices
using optional SFP transceivers.
Twisted-Pair Devices
Each device requires an unshielded twisted-pair (UTP) cable with RJ-45 connectors at both
ends. Use Category 5, 5e or 6 cable for 1000BASE-T connections, Category 5 or better for
100BASE-TX connections.
Cabling Guidelines
The RJ-45 ports on the switch support automatic MDI/MDI-X pinout configuration, so you can
use standard straight-through twisted-pair cables to connect to any other network device
(PCs, servers, switches, routers, or hubs). See Appendix B for further information on cabling.
CAUTION
: Do not plug a phone jack connector into an RJ-45 port. This will damage
the switch. Use only twisted-pair cables with RJ-45 connectors that conform to FCC standards.
