![Transition Networks DataBand EV User Manual Download Page 8](http://html1.mh-extra.com/html/transition-networks/databand-ev/databand-ev_user-manual_1151772008.webp)
DataBand E V User Manual
8
© 2012 Patapsco Designs Ltd
4. Safety
Please take a moment to observe the safety notices for this product and its accessories.
4.1. Safety Statements
Caution: Danger of electric shock. The device may be connected to hazardous voltages. Switch to power-
off state before working on the device.
Caution: Danger of electrostatic discharge. Electronic components are sensitive to electrostatic discharges
that might damage the device. Protect the device from electrostatic discharges by wearing an electrostatic
wristband connected to a grounding terminal.
Caution: Interruption of data transmission. Data transmission will be interrupted during any work on the
transmission line and/or deactivation of the power supply. Make sure that that any work will only be
carried out on inactive lines (without data transmission) or during quiet times to reduce interference to live
systems.
Caution: Danger of damage to devices or service interruption. Access by unauthorized third persons may
cause damaged devices and/or interrupted services. Make sure that subracks are only installed in lockable
locations.
Caution: Danger of overvoltage. During faults, dangerous unprotected voltages may be present. Ensure
sufficient grounding of the housings, i.e. by connecting the grounding contact.
Safety Warnings
Safety requirements are not fulfilled unless this equipment is connected to a wall socket outlet with a protective earth (PE) contact.
The power cord used to connect this equipment must be HAR marked and fitted with an IEC320 connector and an ASTA approved
moulded plug.
There are no user serviceable parts in this equipment. All servicing and repair tasks must be undertaken by qualified service
personnel.
Isolation from mains power is achieved by the removal of the main power cord.
Telecommunications Safety
The safety status of ports conform to EN60950.
Connections to ports must be made such that the equipment continues to comply with the standard defined by EN60950 for SELV/
TNV circuits after such connections have been made.