Transition Networks C4110-4848, Install Manual

Page: 6 / 20

Transition Networks S4110 Install Guide
33573 Rev. B https://www.transition.com/ Page 6 of 20
DIP Switch SW1 (Function Settings)
The 8-position DIP switch is labeled CONFIG SWITCHES on the right side of the S4110 enclosure.
The factory default setting is SW1 – 8 in the
ON position (Down). SW5 - 8 settings are not used (‘do not
care’). Use a small, flat-blade screwdriver (or similar tool) to set the DIP switches to site requirements.
Note 1 : Component labeling may vary; the figure above shows SW 1-8 in the position labeled ‘ ON ’
( Down ).
Table 1: DIP Switch SW1 Settings
1 2
3 4 Data Rate
Down Down Down Down
10GE = 10 gigabit Ethernet (also 10GbE or 10
GigE).This is the factory default setting.
Up Down Down Down
10GFC + FEC = 10GbE Fibre Channel with Forward
Error Correction.
Down Up Down Down 10GFC = 10GbE Fibre Channel.
Up Up Down Down
WAN/OC-192+FEC = OC-192 network line with
transmission speeds up to 9953.28 Mbit/s with
Forward Error Correction.
Down Down Up Down
WAN/OC-192 = OC-192 network line with
transmission speeds up to 9953.28 Mbit/s.
Up Down Up Down
8GFC = 8G Fiber Channel with 8.5 gigabaud Line
rate and 1,600 MBps Throughput (at full duplex).
Down Up Up Down
4GFC = 4G Fiber Channel with 4.25 gigabaud Line
rate and 800 MBps Throughput (at full duplex).
Up Up Up Down
2GFC = 2G Fiber Channel with 2.125 gigabaud Line
rate and 400 MBps Throughput (at full duplex).
Down Down Down Up 1GFC = 1GbE Fibre Channel.
Up Down Down Up 2.5G = 2.5 gigabit Ethernet.
Down Up Down Up 1GE = 1 gigabit Ethernet.
Up Up Down Up OC-48 = network line with transmission speeds of up
to 2488.32 Mbit/s.
Down Down Up Up Reserved (Default).
Up Down Up Up Reserved (Default).
Down Up Up Up Reserved (Default).
Up Up Up Up Reserved (Default).