TransCore MPRX, System Manual

Page: 50 / 208

MPRX
TransCore Proprietary 4–3
Table 4 – 1 Installation Accessories
Additional Materials Needed for Testing
You need these additional materials to perform the pre-tests on the MPRX:
• Test tags, supplied by the TransCore dealer or distributor.
Note: The test tag must be mounted flush against a metal backplane.
• Suitable 24 to 110VDC or 12 to 24VDC power wiring for the MPRX
• Audible circuit tester and 9V DC battery for circuit tester power
• Wire stripper
• At least one MPRX-compatible antenna
• Suitable RF interface coaxial cable
Pre-installation Testing of the MPRX
Before installing the MPRX permanently at the site, you should use an audible circuit
tester to confirm that the MPRX has power and can read a tag that is in the tag read
zone.
Testing the MPRX Using an Audible Circuit Tester
An audible circuit tester is also called a buzz box. These boxes are available at some
electronic parts supply stores, or you can make a buzz box, as shown in
Figure 4 – 1 .
The buzz box is powered by a 9V DC battery and is equipped with two alligator-clip
leads. When you touch the leads together, the box makes an audible sound.
Part No.
Description
MPRX Cable
MPRX Cable
MPRX Cable
MPRX Cable
20-7001-001 MPRX check tag accessory kit