TransCore MPRX, System Manual

Page: 180 / 208

System Guide
TransCore Proprietary D–2
Appendix D Command Quick Reference
This appendix lists the default configuration settings for the
Multiprotocol Reader Extreme (MPRX) and its commands. Commands
are listed both numerically and alphabetically.
Command Syntax
The command numbers consist of from 2 to 4 hex digits. The letters N or S may follow a
command number. The letter N indicates that part of the command number is variable. The
letter S indicates the requirement for an alphanumeric data string that is to be included
immediately following the command number. Hex digits (0–9, A–F) in either uppercase
or lowercase characters may be used in data strings and for hex digits A–F. For more
information refer to Chapter 5,
“This chapter provides software-related information for the
Multiprotocol Reader Extreme (MPRX) System.” on page 5–2.
Table D – 1
lists factory default settings.
Table D – 2
lists, in numerical order, all of the
commands available to users.
Table D – 3
lists the same commands by command name.
Factory Default Settings
Table D – 1 lists the factory default settings for the MPRX.
Table D – 1 MPRX Default Configuration Settings
Parameter Setting Command
Operating mode Data 00
Baud rate 9600 1005
Stop bits 1 1010
Parity None 1020
Time and data appended Enabled 302
Auxiliary information appended Disabled 310
Unique ID code criteria
Separation of 1 ID 4100
Valid ID code criteria Acquisition of 1 ID 4200
Uniqueness time-out
2 minutes 441
Tag translation mode Disabled
452
Multi-tag sort Disabled 454
SeGo protocol tag initialization
during multi-tag sort Enabled 456