TransCore MPRX, System Manual

Page: 138 / 208

System Guide
TransCore Proprietary 8–12
Reports
The MPRX can be configured to transmit presence without tag reports and input status
change reports. A presence without tag report is transmitted in data mode only, and only
if the system has a presence detector. This report is sent if a presence is detected without
the detection of a valid tag ID. Refer to sections
“529 Display Presence Input Status” on
page 7–18 and “690N Select Presence Without Tag Report Option” on page 7–30 .
To set presence reporting
1. Ensure that the host device is in command mode.
2. Enter command #529 to display presence input status and press ENTER. P0 indicates
presence without tag reports disabled (factory default), and P1 indicates presence
without tag reports enabled.
3. Enter command #6901 to enable presence without tag reports, or enter command
#6900 to disable presence without tag reports (factory default). Press ENTER.
To set input status change reporting
1. Ensure that the host device is in command mode.
2. Enter command #560 to display input status change report options and press
ENTER.
• E0 = input status change reports disabled (factory default)
• E1 = input status change reports enabled
• M0 = reporting disabled (factory default)
• M1 = changes on input0 reported
• M2 = changes on input1 reported
• M3 = changes on either input reported
Reset Reader
Command #63 Reset Reader resets uniqueness, clears the power fail bit, and transmits
the sign-on message. The reader returns to data mode following the completion of this
command.
Note: This command does not reset any of the configuration parameters.
Refer to “63 Reset Reader” on page 7–25