TransCore MPRX, System Manual

Page: 129 / 208

MPRX
TransCore Proprietary 8–3
Parameter Setting Command
SeGo protocol tag initialization
during multi-tag sort Enabled 456
Reader ID number 00 6000
Communications protocol Basic 610
Error correcting protocol (ECP)
timeout 12.7 sec 612FE
Flow control Software (XON/XOFF) 6141
Echo mode Enabled 6171
ATA operating range Maximum 6431F
RF attenuation Full power 64400
SeGo protocol tag operating
range Maximum 6451F
Presence without tag reports Disabled 6900
RF-off control Timeout or no presence 6922
RF timeout Never true 693F
Input inversion Disabled 6940
Serial number SSSSSS 695
Store hardware configuration Hardware configuration
not known 696
Automatic periodic RF status
report Disabled 830
Configuring Parameters with Terminal Emulation
Software
To configure the MPRX using a PC and terminal emulation software to manually enter
MPRX host commands, follow the instructions in the section
“Connecting the MPRX to the
Host” on page 4–12 Then, enter the appropriate configuration commands through the
terminal emulation software on the host.
Refer to
“Chapter 7 Commands” on page 7–2 for a detailed description of all available
configuration commands.
Starting the Terminal Emulation Software
You can use a PC and any terminal emulation software to enter the host commands to
download flash software, configure reader operating parameters, perform diagnostics,
and retrieve tag data. The following procedures show examples using Hyper Terminal, an
application included with Microsoft Windows. Most terminal emulation applications have a