TransCore MPRX, System Manual

Page: 120 / 208

MPRX Reader
TransCore Proprietary 7–33
Table 7 – 15 Input Inversion Options
Reader response:
Done
695S...S Set Serial Number (Factory Default)
Command
#695
assigns the reader serial number according to the format:
695SSSSSS
where
SSSSSS
is the serial number.
The serial number may contain as many as six uppercase or lowercase ASCII alphanumeric
characters.
Note: The factory-assigned serial number of the reader contains seven characters.
However, to maintain backward compatibility, the reader software allows only six
characters to be entered. When setting the serial number, skip the fourth (middle)
character of the seven-character number shown on the reader product label.
Note: Once assigned, the serial number is preserved during power-down and the
loading of default parameters.
Reader response:
Done
696S...S Store Hardware Configuration String (Factory Default)
Command
#696S...S
stores hardware configuration information into reader memory.
The hardware configuration string is assigned according to the following format:
696S...S
where
S...S
is the hardware configuration string that may contain as many as 20
uppercase or lowercase ASCII alphanumeric characters.
Note: Once assigned, configuration information is preserved during power-down and
the loading of default parameters.
Reader response:
Done
Command Option
6940 Disable input inversion (factory default)
6941 Enable input inversion