TransCore MPRX, System Manual

Page: 93 / 208

User Guide
TransCore Proprietary 7–6
delay.
100N Select Baud Rate
Command
#100N
selects the reader baud rate. The factory-default setting is 9600
baud. The N variable specifies the baud rate shown in Table 7 – 1 .
Table 7 – 1 Select Baud Rate Commands
Caution
If ECP is enabled, ensure that the ECP timeout is sufficient for the new baud rate.
Refer to “Timing and Synchronization” on page 6–9.
Reader response:
Done
101N Select Stop Bits
Command #101N selects the number of stop bits for reader character transmission. The
factory default setting is 1 stop bit. The N variable specifies the number of stop bits as
indicated in
Table 7 – 2 .
Table 7 – 2 Select Stop Bits Commands
Reader response:
Done
102N Select Parity
Command #102N selects the reader parity setting. The factory-default setting is parity
disabled. The N variable specifies parity as shown in
Table 7 – 3 .
Command Baud Rate Selected
1002 1200
1003 2400
1004 4800
1005 9600 (factory default)
1006 19.2 K
1007 38.4 K
Command Stop Bits Selected
1010 1 (factory default)
1011 2