TransCore MPRX, System Manual

Page: 188 / 208

System Guide
TransCore Proprietary D–10
Number Command Name Reader Message
552 Request sensor status change Reader response:
MUX x<0 to 3> <MPRX>
where
x = 0 antenna multiplexing disabled, RF
on port 0 only
x = 1 antenna multiplexing between RF
ports 0 and 1 when sense0 active
x = 2 antenna multiplexing between RF
ports 0 and 1 when sense0 active and
RF port 2 when sense1 active
x = 3 antenna multiplexing between RF
ports 0 and 1 when sense0 active and
RF ports 2 and 3 when sense1 active
MPRX = MPRX mode selected
560 Display input status change SSTC Ex Mx
E0 = status change reports disabled
E1 = status change reports enabled
M0 = no reporting
M1 = report change on input0 M2 =
report change on input1 M3 = report
change on either input
570 Display operating mode status ATA:<E, D> eGo:<I, F, D> SeGo:<I, F, D>
IAG:<E, D> Sort:<E, D>
I = ID (64 bits) E = Enabled
F = Full transaction (eATA) D = Disabled
577 Report buffered handshakes XX = number of handshakes
60NN Set reader ID number NN =
00–FF
(00 = factory default) Done
610 Select basic protocol Done
611 Select ECP protocol Done
612NN Set ECP timeout
NN = 01–FE (1–255)
timeout = 50 ms * NN (if NN =
FF, timeout is disabled) Done