29
BIOS SETUP
•
Standby Mode
After the selected period of system inactivity (1 minute to 1 hour), the fixed disk drive and the
video shut off while all other devices still operate at full speed.
•
Suspend Mode
After the selected period of system inactivity (1 minute to 1 hour), all devices except the CPU
shut off.
•
HDD Power Down
After the selected period of system inactivity (1 to 15 minutes), the hard disk drive powers
down while all other devices remain active.
•
Throttle Duty Cycle
When the system enters Doze mode, the CPU clock runs only part of the time. You may select
the percent of time that the clock runs.
•
PCI/VGA Active Monitor
When enabled, any video activity restarts the global timer for Standby Mode.
•
Soft-Off by PWR-BTTN
When set to “Instant-off”, the ATX switch can be used as a normal system power off button.
When set to “Delay 4 seconds”, you need to hold the ATX switch for more than 4 seconds if
you want to power off system.
•
Ring Wake Up
This allows either setting of “Enabled” or “Disabled” for powering up the computer when the
modem receives a call and the computer is in the soft-off mode.
•
LAN Wake Up
This allows you to remotely power up your system through your network by sending a wake up
frame or signal.
NOTE: This feature requires the network interface and an ATX power supply with at
least 720mA +5 V standby power.
•
Time Wake Up
This item can power on your computer at the time you selected.
•
Reload Global Timer Events
When enabled, an event occurring on each device listed below restarts the global timer for
Standby mode.
