NAME/CODE DESCRIPTION CODE/VALUE
A10
Auto Power Off
Period
Selects the auto off time period in minutes:
“Off” = Disabled (Always ON)
Off
1, 2, 3,
5
√
, 8,
10, 15, 20, 30
A11
Hold Model
Enable
Activates the “Hold” mode where weight of the object on the platform
is frozen on the display until the applied weight is decreased to one-
half of the memorized weight. This is used in conjunction with the
Motion Band setting (F5) to capture an unstable load, such as
livestock.
“0” = Disabled, “1” = Enabled
0
√
1
A12
Handshaking
Enable
Enables hardware handshaking for Print Ticket Mode. Valid only
when
A6
is set to “1”.
"0" = Disable Handshaking "1" = Enable Handshaking
0
√
1
A13
Print Header
Tells MP-20 printer to print the header information. Valid only when
A6
is set to “1”.
"0" = Do NOT Print Header "1" = Print Header
0
√
1
5.2 USER MENU PROCEDURES
This section provides instructions for all of the User Menu procedures.
5.2.1 ID Number Entry (A8)
1. While in the User Menu mode, scroll to "
A 8
", then scroll down once using the
ZERO key to enter the ID Number menu.
2. The display will momentarily show "
ID NO
", followed by a value with one flashing
digit. This value will be the current ID number value.
3. Use the four directional keys (shown in Figure 5-1 below) to adjust the displayed
value to the actual ID Number value. Increase the flashing digit by pressing the
UNITS key. Decrease the flashing digit by pressing the ZERO key. Pressing the
PRINT key or the TARE key will change the position of the flashing digit.
USER MODE KEY FUNCTIONS
ZERO
GROSS
NET
TARE
SET
UNITS
Figure 5-1: User Menu Key Assignments
4. After setting the exact value, press the NET/GROSS key to save the ID Number
value. The display will show "
SET
" momentarily, then revert back up to A8.
Page 5-3
