TI-500-SSB (without slide switch)
1. Remove the rear cover and locate the two-position dipswitch.
2. Place switch #1 to the OFF position.
Note:
On certain units, the dipswitch position will be exactly the opposite.
3. Power on the indicator. The indicator shows ” F 1” to indicate that you are in Setup
Menu mode.
3.2.3 NAVIGATING IN THE SETUP MENU
Use the directional keys shown in Figure 3-1 to move around in the Setup Menu Chart
shown in Figure 3-2 on the following page.
1.
To move to a new “F” heading, use the TARE (left) or PRINT (right) key to move right
or left in the Setup Menu Chart.
2.
To move to the selection level, press the ZERO (down) key once. The current saved
selection is shown.
3.
To view the available selections for the current “F” heading, use the TARE (left) or
PRINT (right) key to move through the selection field.
4.
To save a new selection, press the NET/GROSS (Set) key .To exit without saving,
press the UNITS (up) key to return to the current “F” heading.
5.
Repeat Steps 1 through 4 until the Setup Menu is programmed.
SET
Figure 3-1: Setup Menu Key Assignments
Page 3-2
