26 User Manual
Figure 5-9 Clear Data Verify Interface
Notes:
1)
This operation step requires password (default value: 1001).
2)
If this operation is done, all the data in the memory will be cleared, so
backup of all the data before clear is recommended.
5.4.1.4. Power Management Setting
when pressing the
“
enter” key, you will find a pull-down menu. Choose “
Power
Management
” menu and press “enter” to get into
Power Management
state. In this
menu, press “OK” to set power limit and factor type, if choosing “Default”, data
set default value.
Figure 5-10
Power Management
Interface
5.4.2. Energy yield
Press the “enter” key, and then you will find a pull-down menu. Please move the
cursor to “E-Week” by pressing the “up” or “down” key, then press “enter”, the
relevant information will be shown. (E-Week is default status)
Figure 5-12 week Energy Wave
