1 & 2 ft. Antenna Installation Manual
2.0 Mounting
© 2011 Trango Systems, Inc. All rights reserved. LT-9035 Rev B
5
2.0 Mounting
Step 1: Assemble Mounting Bracket.
From the mounting kit, first attach the mounting bracket to the antenna
using 3 each of the M10x40mm bolts and washers as shown in Figure 1.
NOTE: It is recommended to apply a a small amount of lubricant such
as anti-seize grease to the threads of the bolts to prevent binding as
the nuts are tightened. The nuts should be turned slowly and not
over-torqued This will ease the installation and alignment
significantly.
Maximum torque for all mounting bolts is 22 N-m or 15 lb ft. Turn the nuts
slowly as they are tightened down. This will ease the installation and
alignment significantly
IMPORTANT
:
Choose the side to attach mounting bracket based on
the location of the pole relative to the antenna (See Figure 2 and 3)