![background image](http://html1.mh-extra.com/html/trane/vav-vv550-lontalk/vav-vv550-lontalk_installation-and-operation-manual_1149849050.webp)
50
VAV-SVP01A-EN
VAV VV550 Controller Programming and Operation
Name Location/ID:
VAV controller name
Neuron ID:
Each VAV VV550 Controller will have an Echelon chip that has a distinctive
identification number called a neuron ID. This replaces the addressing that was done with dip
switches on a DDC Comm 4 VAV UCM 4.2 controller.
Device State/Mode:
This point indicates if Rover is communicating with controller. The two
states are Configured On line or Not Communicating
Manufacturer ID:
Trane will be the manufacture displayed for the VV550 controller
Software Revision:
This is the controller revision programs that has been downloaded into this
controller
Note:
If unit is not operating properly it could be a software issue and technical support will need
the revision number.
Self Documentation String:
Indicates Tracer VV550/551 VAV controller.
Figure 37. General tab
Summary of Contents for VAV VV550 LonTalk
