Figure 11.
Operating envelope
R410A Operating Map - Superheat 20F
50
60
70
80
90
100
110
120
130
140
150
160
170
180
190
-30
-20
-10
0
10
20
30
40
50
60
70
Evaporating temperature (°F)
Co
nd
en
s
ing
t
e
mp
eratu
re (°
F)
R410A Operating Map - Superheat 20F
General Information
18
PART-SVN234B-EN
Refrigerant Type
Start to Finish™ compressors are approved for use with
R-410A refrigerant only. Any use of hydrocarbon
refrigerants or air is strictly prohibited!
Transportation, Handling, and
Storage
The compressor must be handled in the vertical position
(maximum 15-degree offset from vertical). Should the
compressor be handled in an upside down position, its
suitability for its use can not be guaranteed.
NOTICE
Improper Handling!
Improper handling of the compressor resulting from
being handled or transported in the upside position,
dropped or tipped over could result in internal damage
to the compressor and it is recommended that the
compressor not be put into service.
Damage to compressor or packaging should be reported
to the shipper immediately.
Use a proper method of lifting the compressor, both lifting
ears must be used with a spreader bar.
WARNING
Heavy Objects!
Failure to follow instructions below or properly lift unit
could result in unit dropping and possibly crushing
operator/technician which could result in death or
serious injury, and equipment or property-only damage.
Ensure that all the lifting equipment used is properly
rated for the weight of the unit being lifted. Each of the
cables (chains or slings), hooks, and shackles used to
lift the unit must be capable of supporting the entire
weight of the unit. Lifting cables (chains or slings) may
not be of the same length. Adjust as necessary for even
unit lift.
For approximate compressor weight, see
