Installation
10
ACC-SVN199E-EN
6. Install the power exhaust onto the unit using 9 screws
as shown in
7. Using field supplied silicone sealant, seal all seams on
the power exhaust and make sure they are all water-
tight. See
.
8. Proceed to
for wire routing
and connections.
Close Out Installation
Once all the wiring connections are made, replace the filter
access panel and close the unit disconnect switch.
Figure 14.
Apply gasket
Figure 15.
Assemble power exhaust
Gasket
Figure 16.
Seal seams on power exhaust
Seal along end
panel flanges
(both sides)
Summary of Contents for Power Exhaust Foundation BAYPWRX320
Page 15: ...Notes ACC SVN199E EN 15...
