4
MCC-SVN02A-EN
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
mor
e than
100 cm.
more than
100 cm.
Lock Nut
Washers
Suspension
Bracket
Cross Section
of Air Outlet
Indoor Unit Installation
Where to install Indoor Unit
• There should not be any heat
source or steam near the unit.
• There should not be any obstacles
to prevent the air circulation.
• A place where air circulation in the
room will be good.
• A place where drainage can be
easily obtained.
• A place where noise prevention is
taken into consideration.
• Do not install the unit near the
door way.
Indoor Unit Installation
• Select the location where a space
is more than 100 cm. as shown in
figure 1 also ensure that the
position dose not interfere with
light fitting, sprinkle head, etc.
• Determine the ceiling hole by using
the paper pattern.
- Determine the mounting position
• Hang the four mounting rods to the
positions marked as picture shown
in figure 3 (using twelve nuts and
eight washers to support the
suspension brackets). Suspend
the unit to the mounting rods.
Lock the nuts, ensure for good
drainage, and check whether the
unit is on horizontal level by using
leveling guage.
• Install the leveling metal plate to
adjust the gap between the unit
and a ceiling, fixing the screws
paper pattern.
• Remove four screws (M8). Fix the
front panel with the units by tighten
up four screws (M8).
Caution:
Over tightening the screws
will distort the front panel.
