Trane Foundation GBC180, Installation, Operation And Maintenance Manual

Page: 18 / 52

18 RT-SVX51H-EN
Installation
Unit Foundation
W WA AR RN NIIN NG G
R Riisskk o off R Ro oo off C Co olllla ap pssiin ng g!!
F Fa aiillu urre e tto o e en nssu urre e p prro op pe err ssttrru uccttu urra all rro oo off ssu up pp po orrtt
cco ou ulld d cca au usse e tth he e rro oo off tto o cco olllla ap psse e,, w wh hiicch h cco ou ulld d
rre essu ulltt iin n d de ea atth h o orr sse erriio ou uss iin njju urry y a an nd d p prro op pe errtty y
d da am ma ag ge e..
C Co on nffiirrm m w wiitth h a a ssttrru uccttu urra all e en ng giin ne ee err tth ha att tth he e rro oo off
ssttrru uccttu urre e iiss ssttrro on ng g e en no ou ug gh h tto o ssu up pp po orrtt tth he e
cco om mb biin ne ed d w we eiig gh htt o off tth he e rro oo offccu urrb b,, tth he e u un niitt,, a an nd d a an ny y
a acccce esssso orriie ess..
N NO OT TIIC CE E
W Wa atte err D Da am ma ag ge e!!
F Fa aiillu urre e tto o ffo ollllo ow w iin nssttrru uccttiio on nss b be ello ow w cco ou ulld d rre essu ulltt iin n
e eq qu uiip pm me en ntt a an nd d p prro op pe errtty y d da am ma ag ge e..
N No on n--ffa acctto orry y p pe en ne ettrra attiio on nss tth hrro ou ug gh h tth he e b ba asse e o off tth hiiss
u un niitt a arre e n no ott a allllo ow we ed d.. A An ny y p pe en ne ettrra attiio on n iin n tth he e b ba asse e
o off tth he e u un niitt m ma ay y a affffe ecctt tth he e w wa atte err ttiig gh htt iin ntte eg grriitty y o off
tth he e u un niitt a an nd d lle ea ad d tto o w wa atte err lle ea akkss iin ntto o tth he e
cco on nd diittiio on ne ed d ssp pa acce e..
N NO OT TIIC CE E
R Ro oo off D Da am ma ag ge e!!
S Sy ysstte em m cco on ntta aiin nss o oiill a an nd d rre effrriig ge erra an ntt u un nd de err h hiig gh h
p prre essssu urre e.. R Ro oo offss ssh ho ou ulld d b be e p prro otte ecctte ed d ffrro om m
e ex xp po ossu urre e tto o o oiillss a an nd d rre effrriig ge erra an ntt iin n tth he e ssy ysstte em m.. IIff
rro oo offtto op p iiss n no ott p prro otte ecctte ed d,, d da am ma ag ge e tto o tth he e rro oo off m ma ay y
o occccu urr..
IIm mp po orrtta an ntt:: Refer to local building codes for proper
installation. All installation must comply
with local building codes.
Horizontal Units
N No otte ess::
• For complete step by step instructions on
how to install a Horizontal Conversion Kit,
please refer to ACCSVN159*- EN.
• For units with optional Condensate
Overflow Switch (COF) , the switch will not
work properly if unit is not level or slightly
sloped toward switch.
• To assure proper condensate flow during
operation the unit and the curb must be
level.
If the unit is installed at ground level, elevate it above
the snow line. Provide concrete footings at each
support location with a “full perimeter” support
structure or a slab foundation for support. Refer to
Table 1, p. 16 for the unit’s operating and point loading
weights when constructing a footing foundation.
If anchoring is required, anchor the unit to the slab
using hold down bolts or isolators. Isolators should be
installed to minimize the transmission of vibrations
into the building.
For rooftop applications, if anchoring is required,
anchor the unit to the roof with hold-down bolts or
isolators.
Check with a roofing contractor for proper
waterproofing procedures.
Ductwork
Elbows with turning vanes or splitters are
recommended to minimize air noise due to turbulence
and to reduce static pressure.
When attaching the ductwork to the unit, provide a
watertight flexible connector at the unit to prevent
operating sounds from transmitting through the
ductwork.
All outdoor ductwork between the unit and the
structure should be weather proofed after installation is
completed.
N No otte e:: For sound consideration, cut only the holes in the
roof deck for the ductwork penetrations. Do not
cut out the entire roof deck within the curb
perimeter.
If a Curb Accessory Kit is not used:
1. The ductwork can be attached directly to the
factory-provided flanges around the unit’s supply
and return air openings. Be sure to use flexible duct
connections at the unit.
2. For “built-up” curbs supplied by others, gaskets
must be installed around the curb perimeter flange
and the supply and return air opening flanges.
General Unit Requirements
W WA AR RN NIIN NG G
P Prro op pe err F Fiie elld d W Wiirriin ng g a an nd d G Grro ou un nd diin ng g
R Re eq qu uiirre ed d!!
F Fa aiillu urre e tto o ffo ollllo ow w cco od de e cco ou ulld d rre essu ulltt iin n d de ea atth h o orr
sse erriio ou uss iin njju urry y..
A Allll ffiie elld d w wiirriin ng g M MU US ST T b be e p pe errffo orrm me ed d b by y q qu ua alliiffiie ed d
p pe errsso on nn ne ell.. IIm mp prro op pe errlly y iin nsstta alllle ed d a an nd d g grro ou un nd de ed d
ffiie elld d w wiirriin ng g p po osse ess F FIIR RE E a an nd d E EL LE EC CT TR RO OC CU UT TIIO ON N
h ha azza arrd dss.. T To o a av vo oiid d tth he esse e h ha azza arrd dss,, y yo ou u M MU US ST T ffo ollllo ow w
rre eq qu uiirre em me en nttss ffo orr ffiie elld d w wiirriin ng g iin nsstta alllla attiio on n a an nd d
g grro ou un nd diin ng g a ass d de essccrriib be ed d iin n N NE EC C a an nd d y yo ou urr llo occa all//
sstta atte e//n na attiio on na all e elle eccttrriicca all cco od de ess..
The checklist listed below is a summary of the steps
required to successfully install a commercial unit. This
checklist is intended to acquaint the installing
personnel with what is required in the installation